User's Manual

CY920 Regulatory Compliance Information
Revision 0.0 (10/2014)
Preliminary
1
APPENDIX A: CERTIFICATION
NOTICES
The CY920 module is not tested for Federal
Communications Commission (FCC). The following
statements are not valid until the production version
modules are tested. It is planned to certify the
production version of the CY920 module as soon as
possible after production versions are made.
Federal Communications Commission
Interference Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and radiates radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/ TV
technician for help.
Caution:
Any changes or modifications not
expressly approved by the grantee of this
device could void the user's authority to
operate the equipment.
Applicable to UNII device only: The
device is restricted to indoor use when
operating in the 5.15 GHz to 5.25 GHz
frequency band. FCC requires this
product to be used indoors for frequency
range 5.15 GHz to 5.25 GHz to reduce
the potential for harmful interference to
co-channel mobile satellite systems.
Labeling Requirements
This device complies with Part 15 of the FCC Rules. The
operation is subject to the following two conditions: the
device may not cause harmful interference, and the
device must accept any interference received, including
interferences that may cause undesired operations.
RF Exposure Warning
This equipment must be installed and operated in
accordance with provided instructions. The antennas
used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction
with any other antenna or transmitter. End users and
installers must be provide with antenna installation
instructions and transmitter operating
conditions for satisfying RF exposure compliance.
Information for the OEMs or Integrators
The following statement must be included in all
versions of this document supplied to OEMs or
integrators, but should not be distributed to the end
user.
“This device is intended for OEM or integrators only.
Please see the full Grant of Equipment document for
other restrictions. This device must be operated and
used with a locally approved Access “.
Information to be Supplied to the End
User by the OEM or Integrator
The following regulatory and safety notices must be
published in all documentation supplied to the end user
of the product or system, incorporating an adapter in
compliance with local regulations.
“The host system must be labelled with: Contains FCC
ID:ZQO-CY920‘X’ and IC: 2581A-CY920‘X’, FCC ID
displayed on the label.
The letter shown in Ordering Guide Part Number
column should be substituted for ‘X’. For example, for
the CY920-C module, the label text should be
"Contains FCC ID:ZQO-CY920C"and "IC:
2581A-CY920C. The label text should be updated
according to the table shown in the “Ordering Guide”
section of the datasheet.