Daim Ntawv Qhia Tus Neeg Siv
Table Of Contents
2.4. Con*guration of MEP parameters
$0-;A6<)@.7:+.55-84->-4+41+755)6,1;);.7447?;
'0-:-
@)584-
mep <1-8191>
admin-state { enable | disable }
alarm-level <alarm_level>
alarm-time-absent <alarm_time_absent_ms>
alarm-time-present <alarm_time_present_ms>
continuity-check
direction { up | down }
interface <port_type> <port>
mep <mepid>
no continuity-check
no remote mep { <rmepid> | all }
no smac
pcp <pcp>
remote mep <rmepid>
smac <mac>
vlan { untagged | <vid> }
mep Create or modify a MEP
admin-state Enable or disable this MEP.
alarm-level If a defect is detected with a priority higher than this level, a
fault alarm
notification will be generated.
alarm-time-absent The time in milliseconds that defects must be absent before a
fault alarm
notification is reset. Default is 10000 ms.
alarm-time-present The time in milliseconds that defects must be present before a
fault alarm
notification is issued. Default is 2500 ms.
continuity-check Enable or disable (no-form) generation of conitinuity-check
messages (CCMs)
direction Set whether this MEP is an Up- or a Down-MEP.
interface Select an interface to configure.
mep Create or modify a Maintenance association EndPoint (MEP).
no Negate a command or set its defaults.
pcp Choose PCP value in PDUs' VLAN tag. Not used if untagged.
remote Specify the Remote MEPs that this MEP is expected to receive CCM
PDUs from.
smac Set a Source MAC address to be used in PDUs for this MEP. Default
to use
interface's.
vlan VLAN commands.
76C/=:)<176=1,- 8841+)<1767<-
$ !)/-7.