Daim Ntawv Qhia Tus Neeg Siv

ManualsBrandsMICROCHIP ManualsOtherMICROCHIP SAMRH707 100-Pin Motor Control Plug-In Module

Table Of Contents

SAMRH707

SAMRH707 100-Pin Motor Control Plug-In Module

Information Sheet

Introduction

The SAMRH707 100-pin Motor Control Plug-in Module (PIM), SAMRH707F18-PIM, is designed to demonstrate the

capabilities of the SAMRH707 164-pin Motor Control devices with the following hardware:

• The dsPICDEM

™

MCLV-2 development board (DM330021-2) (using external op amps)

• The dsPICDEM

™

MCHV-3 development board (DM330023-3) (using external op amps)

• The dsPICDEM

™

MCSM development board (DM330022)

All development boards support 100-pin PIM interfaces. The SAMRH707 100-pin Motor Control PIM is designed to

use on board external op amps for signal conditioning of analog feedback inputs when used with MCLV-2 or MCHV-3.

For the dsPICDEM

™

MCLV-2 development board, insert the external op amp configuration board (included with the

development board) at header J14.

For the dsPICDEM

™

MCHV-3 development board, insert the PFC–EXT-OPAMP configuration board (included with

the development board) at header J4.

The following figures show the op amp configuration board for the dsPICDEM

™

MCLV-2 and dsPICDEM

™

MCHV-3

development boards.

Figure 1. Op amp Configuration Board for dsPICDEM

™

MCLV-2

and its subsidiaries

Other

DS60001796A-page 1

Summary of content (14 pages)

PAGE 1
SAMRH707 SAMRH707 100-Pin Motor Control Plug-In Module Information Sheet Introduction The SAMRH707 100-pin Motor Control Plug-in Module (PIM), SAMRH707F18-PIM, is designed to demonstrate the capabilities of the SAMRH707 164-pin Motor Control devices with the following hardware: • • • The dsPICDEM™ MCLV-2 development board (DM330021-2) (using external op amps) The dsPICDEM™ MCHV-3 development board (DM330023-3) (using external op amps) The dsPICDEM™ MCSM development board (DM330022) All development boards
PAGE 2
SAMRH707 Figure 2. Op amp Configuration Board for dsPICDEM™ MCHV-3 WARNING Do not connect non-isolated oscilloscope probes to probe any traces while using the PIM with the dsPICDEM MCHV-3 development boards. Instead, use a high-voltage differential probe, rated in excess of 600 VRMS (Common mode). Failure to heed this warning could result in hardware damage. © 2022 Microchip Technology Inc.
PAGE 3
SAMRH707 Table of Contents Introduction.....................................................................................................................................................1 1. Jumpers Configuration............................................................................................................................ 4 2. PIM to MCU Mapping..............................................................................................................................5 3.
PAGE 4
SAMRH707 Jumpers Configuration 1. Jumpers Configuration The SAMRH707 100-pin Motor Control PIM can be used on the following boards: The dsPICDEM™ MCLV-2 development board (DM330021-2) The dsPICDEM™ MCHV-3 development board (DM330023-3) The dsPICDEM™ MCSM development board (DM330022) • • • For that, the jumpers are configured as follows: Table 1-1.
PAGE 5
SAMRH707 PIM to MCU Mapping 2. PIM to MCU Mapping The following table provides the static mapping between the 100-pin PIM pins and the 164-pin device pins. Table 2-1.
PAGE 6
SAMRH707 PIM to MCU Mapping ...........
PAGE 7
SAMRH707 PIM to MCU Mapping ...........
PAGE 8
138 139 140 141 142 145 146 147 148 149 150 151 152 153 154 155 156 160 161 162 3 4 5 6 7 8 9 10 11 12 13 14 PA0 PA1 PA2 PA3 PA4 PA5 PA6 PA7 PA8 PA9 PA10 PA11 PA12 PA13 PA14 PA15 PA16 PA17 PA18 PA19 PA20 PA21 PA22 PA23 PA24 PA25 PA26 PA27 PA28 PA29 PA30 PA31 PA0 PA1 PA2 PA3 PA4 PA5 PA6 PA7 PA8 PA9 PA10 PA11 PA12 PA13 PA14 PA15 PA16 PA17 PA18 PA19 PA20 PA21 PA22 PA23 PA24 PA25 PA26 PA27 PA28 PA29 PA30 PA31 PC0 PC1 PC2 PC3 PC4 PC5 PC6 PC7 PC8 PC9 PC10 PC11 PC12 PC13 PC14 PC15 PC16 PC17 PC18 PC19 PC20 PC21
PAGE 9
PD11 PWR_3V3 PB15 PB18 PB17 NRST GND PWR_3V3 PWR_3V3 PA16_1 PD13 PA5 PA3 PA1 PA7 PA8 PA6 J10 1 2 HDR-2.
PAGE 10
SAMRH707 Revision History 3. Revision History The revision history describes the changes that were implemented in the document. The changes are listed by revision, starting with the most current publication. Revision Date Description A 10/2022 Initial Revision © 2022 Microchip Technology Inc.
PAGE 11
SAMRH707 Microchip Information The Microchip Website Microchip provides online support via our website at www.microchip.com/. This website is used to make files and information easily available to customers.
PAGE 12
SAMRH707 by updates. It is your responsibility to ensure that your application meets with your specifications. Contact your local Microchip sales office for additional support or, obtain additional support at www.microchip.com/en-us/support/ design-help/client-support-services. THIS INFORMATION IS PROVIDED BY MICROCHIP "AS IS".
PAGE 13
SAMRH707 Quality Management System For information regarding Microchip’s Quality Management Systems, please visit www.microchip.com/quality. © 2022 Microchip Technology Inc.
PAGE 14
Worldwide Sales and Service AMERICAS ASIA/PACIFIC ASIA/PACIFIC EUROPE Corporate Office 2355 West Chandler Blvd. Chandler, AZ 85224-6199 Tel: 480-792-7200 Fax: 480-792-7277 Technical Support: www.microchip.com/support Web Address: www.microchip.