Operator`s manual

Printer Commands Chapter 5
400 Operators Manual
42
^A ^D COMMAND
22 Change SW2: Software dip switch #2. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******.)))),
******.)))),*
*****.)))),**
***** RRR Power-up Label Format
***** 000=ALWAYS EPROM Format 1
***** 001=ROM or Saved Format File 1
***** 010=ROM or Saved Format File 2
***** 011=ROM or Saved Format File 3
***** 100=ROM or Saved Format File 4
***** 101=ROM or Saved Format File 5
***** 110=ROM or Saved Format File 6
***** 111=ROM or Saved Format File 7
****.)))) 1=Use Saved Format File, 0=Rom Format
***.))))) 1=Print Button Enable, 0=Disable
**.)))))) 1=Disable Button Use, 0=Enable
*.))))))) 1=>RESTARTED< Response Enable, 0=Disable
.)))))))) 1=Clear Text Enable, 0=Disable
Position:
1 Clear Text Function: If enabled, all variable text strings will be erased when a
^D25 is processed.
2 >RESTARTED< Response: If the printer has been reset and this switch has been
enabled, the printer will respond with to the first poll by sending the
>RESTARTED< message. If additional enquiries are made the printer will respond
normally. The >RESTARTED< message is only sent once after reset.
3 Button Use: Set to 1, the printer will not allow button use, even for paper feed.
4 Print Button: If this is 0, the button can be used for paper feed, but cannot be
used to initiate label printing.
5 Power-up Format Type: Defines the power-up label format. This parameter
determines whether to use a saved format file for the power-up label, or a ROM
format (defined by positions 6, 7, and 8). The saved format file must be battery
backed to use the saved format file feature. See Appendix C for configuration
instructions and section 5.3.7 for saved format file information. Please consult your
service organization if changes or additions to the fixed ROM formats are required.
6,7,8 Power-up Label Format: These switches decide which format to use at power-up.