Instruction manual

Pg. 15
www.incoe.com
©INCOE® CORPORATION 8/2010
2
M SERIES
INSTRUCTION MANUAL
OPERATION
2.12 START UP
Connect power supply cable to an appropriate power
supply (See sticker on the backside).
Check thoroughly the wiring going to and from the
cabinet.
Switch on the cabinet with the circuit breaker on
backside.
After 10 seconds, the following page is displayed:
After this introduction sequence, you may visualize 3
main pages with successive pushes on the NEXT key.
Then a second intermediate page is displayed:
Cabinet type
Serial No.
of cabinet
Serial No.
of CPU board
Program
release No.
inside CPU