User's Manual

http://www.microcyber.cn
38
Node label:
The long label of the node.
Normally this page only shows the device status. When the Burst command 48 is enabled on
the node, this page will display the HART device status, extended device status, standard status 0,
standard status 1, standard status 2 and standard status 3.
6.2.4 Failed to join
Select "Network Information" -> "Join Failed" to enter the Join Failed page.
Figure 6-10 Join Failed
Node ID:
The long label of the node.
Time:
The time when the failure was added. Format: Month/Day/Year Hour: Minute: Second
Reason:
The reason for joining the failure.
The value is as follows:
- The maximum number of nodes reaches the maximum
- Unable to reach
- Disconnect
- Configuration error
- MIC error
- Join counter error
- No ACL interface
- Join message timeout
- Lost when switching
- AP is not compatible