User's Manual

http://www.microcyber.cn

Choose Use the following IP address from General .

Set IP address as 192.168.2.XX (and it cannot be as the same as gateway, gateway default IP

is 192.168.2.253), and press Tab.

Subnet mask shall be set as 255.255.255.0.

Click OK , close Internet Protocol (TCP/IP) and Local Area Connection .

2.3.2 Connection and Power On

With network cables provided together with gateway, connect one end of cable to Ethernet port

of PC/portable computer, and connect the other end of Ethernet port of gateway, shown as the

Figure below. After the connection between gateway and PC/portable computer, connect 24VDC

(nominal value) power, at least 500mA to power input terminal of gateway.

Figure 2-3 Gateway Connection Terminals Diagram

Warning

Please be careful when connecting wires and terminals.

The user must use the cable pipe entrance located at the bottom of housing when connecting

to gateway. The connection open gateway s cover may press the connection parts and

damage the gateway.

2.3.3 Gateway Configuration

Now the user can log in the gateway and configure it into field control network.

2.3.3.1 Log in Gateway Webpage

1)Open standard network browser.