User's Manual

Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy
Tel. [phone] r.a. Fax. [phone] E-mail [e-mail]
____________________________________________________________________________________________
Yacht Controller
• 14
4. Maintenance
4.1. Replacement of batteries
When the battery discharge LED flashes, it is necessary to replace within a short time both
batteries of the transmitter. It’s a good rule to keep always on board two first quality alkaline
batteries of 1,5V type AAA (LR06) (Duracell or similar).
DANGER:
Before working on the transmitter, make sure that the receiver is OFF. Accidental
pressure on a transmitter switch could in fact activate a boat function and cause a
dangerous situation.
To access the battery, Remove the lower cover of the transmitter with a screwdriver by nserting
it in the slot between the cover and the main container.
Figure 5: Substitution of batteries.
Once the cover is removed, extract the old batteries and replace them with new ones, which
must be of the type indicated at the beginning of this paragraph, paying attention to the polarity
indicated on the back of the radio control cover.
Then put back the cover, properly respecting the polarity indicated on the metallic plate placed
inside.