User's Manual

Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy
Tel. [phone] r.a. Fax. [phone] E-mail [e-mail]
____________________________________________________________________________________________
Yacht Controller
• 15
WARNING:
• This device contains batteries. Attention: batteries must be discarded in
accordance with local and federal regulations.
• Always change the batteries in the radio control transmitter before they lose their
power and discard the old ones according to the regulations in force.
• In the event the batteries have had some leakage, clean it up and replace them
immediately, taking care to properly cleasn your hands to avoid skin problems.
4.2. How to clean the transmitter
After using your Yacht Controller, remove any salt residue by wiping with a soft cloth using fresh
water. ALWAYS avoid soaking it
In case the transmitter has fallen into salt water, immediately turn OFF the receiver following the
procedure described in this manual. Once the transmitter is recovered, remove the lower cover
and remove the batteries. If salt water has entered inside the transmitter dip it momentarily in
distilled water (or in lack of this, pure water) to remove salt residuals. Dry the transmitter using a
hair-dryer (or, in the sun ) until all moisture is completely evaporated..
Before replacing the batteries, be careful that everything is absolutly dry, otherwise short
circuits may occur that would irreparably damage the transmitter.
WARNING:
If the transmitter is turned on when it falls into the water it may have irrevocable
damage. Before using it again TEST IT COMPLETELY TIED UP AT DOCKSIDE
OR IN A SECURE AREA.
If you notice ANY anomalies, contact the retailer or Micro Device Customer Service.