User's Manual

Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy
Tel. [phone] r.a. Fax. [phone] E-mail [e-mail]
____________________________________________________________________________________________
Yacht Controller
• 16
4.3. Problems and malfunctions
This paragraph describes a series of problems and malfunctions which could happen in using
the Yacht Controller system; the possible cause, and possible solutions to the problem For
further assistance please contact your installer or Micro Device S.r.l.
Problem Possible cause Remedy
The receiver does not turn on The control station of the boat
to which the Yacht Contrlloer
receiver is connected has not
been activated
Enable the control station and
turn on the switch of the
Yacht Controller receiver.
The Yacht Controller reciever
switch has not been turned on.
With the transmitter switched
OFF, activate the Yacht
Controller recievr switch and
wait for the acoustic signal as
confirmation.
The Yacht Controller switch
does not have power.
- Check that the switch
has
- power from the
batteries.
- there is no tripped
breakers or fuses
- the switch functions
properly
The transmitter does not turn
on.
No power to transmitter Verify:
- That the batteries and
the cover are properly
installed including
respecting the polarity
as indicated on the
back of the transmitter
- The batteries are
properly charged
The acoustic signal of the
receiver always ON
The transmitter is switched
OFF.
Turn the transmitter ON by
keeping the button pressed at
least three seconds.
The code of the transmitter
does not coresspond to the
receiver
Contact Micro Device S.r.l. for
assistance.