User's Manual

Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy
Tel. [phone] r.a. Fax. [phone] E-mail [e-mail]
____________________________________________________________________________________________
Yacht Controller
• 9
2.2. Activation procedure
In order to activate Yacht Controller, follow the step by step the procedure described in this
paragraph.
• Start the main engines in accordance with the usual procedure.
• Enable the boat command electronics control station to which the Yacht Controller
receiver is connected .
DANGER:
IT IS ABSOLUTELY REQUIRED THAT THE ELECTRONIC CONTROL LEVERS
REMAIN IN THE NEUTRAL POSITION DURING THE USE OF THE YACHT
CONTROLLER SYSTEM.
• Activate the Yacht Controller system with the proper switch (installed on the boat) for
switching on and off the receiver. In about two seconds, the acoustic signal of the device,
will start emitting the acoustic signal which means that the receiver is on but has not
established radio connection with the transmitter.
• Turn the transmitter ON, by pressing the proper on/off button and holding it down more
than three seconds (security time to avoid accidental misuse). The confirmation of the
activation is confirmed by the lighting of the transmission LED.
Figure 3: Transmitter ON/OFF button.
WARNING:
From the moment the system is operating, you must pay maximum attention, since
involuntary pressure on any of the switches will cause the activation of the relative
command.
• At this point, if the reciever and transmitter are communicating, the acoustic signal of the
receiver will stop and the system is ready to function. It will now be possible to control the
engines and the propellers, thrusters, anchors etc., simply pressing the coresponding
switches of the transmitter.
IMPORTANT:
The transmitter automatically turns OFF after approximately four minutes from the last
pressure of any switch..
2.3. Deactivation procedure
Yellow LED of transmission
ON/OFF button