User Manual

2/2/2018 Microduino-Module Ethernet,WIZ - Microduino Wiki
http://wiki.microduinoinc.com/Microduino-Module_Ethernet,WIZ 1/5
Microduino-Module Ethernet,WIZ
Microduino-W5500
Language:
English • 中文
Microduino-W5500 is an ethernet control module developed
by the network chip W5500. Microduino-W5500 must be
stacked with Microduino-RJ45 to compose into a completed
network module, and it can’t be used alone.
Contents [hide]
1 Features
2 Specification
3 Documents
4 Development
5 Application
6 Purchase
7 History
8 Gallery
9 Frontage
10 Back
11 Video
Features
A new all hardware TCP/IP protocol stack network chip since W5100, W5200 and W5300. With lower power consumption and
operating temperature and modified process, and it’s the best solution choice of the embedded Ethernet;
Adopts U-shape 27pin Microduino standard interface, and can be used stacked with module Microduino-RJ45 . Plug and play.
The whole size is smaller;
Open-source hardware circuit design, and compatible-with-Arduino compilation development environment;
With unified Microduino interface specification and abundant periphery modules, which make it can be extended and
connected with other modules and sensors which meet the Microduino interface specification, quickly, conveniently and
flexibly;
With 2.54-spacing female header connector interface, which is convenient for the integration to the pegboard.
Specification
Communication protocol
Supports hardware TCP/IP protocol：TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
Supports 8 separate ports（Socket）to communicate at the same time.
With built-in 10BaseT/100BaseTX Ethernet Phy.
Supports automatic negotiation（10/100-Based full duplex/half duplex）.
Operating characteristic
Supports power down mode.
Supports wake-on-lan.
Supports automatic reply（full duplex/half duplex）
Update rate
Supports high speed serial peripheral interfaces.
With 32k bytes interior send and receive buffer.