User's Manual

802.11a Bridge AP5822 MTI Proprietary Page 13
Chapter 2 Hardware Installation
This chapter provides installation procedures are generally outlined as follows:
n Verify system configuration
n Installing the ODU
n Installing the POE
n Mounting and alignment the antenna
n Connecting external equipment
You may need to use Web Browser to
change or set the MTI AP5822 system’s
operating parameters. Refer to chapter 3,
Bridging network attachment and configuration, for more information.
2-1 Unpacking the Equipment
The tools required for unpacking the system equipment are:
n Utility knife
n Clean, flat working surface
Open the shipping containers, carefully remove the equipment and place it on a clean, flat
working surface. Save the shipping and packing material in case the equipment has to be
returned.
Check the equipment and installation kits against the packing list to ensure that the equipment
part numbers, parts, and ancillary equipment included in the shipment match what is specified
on the packing list. Shipments consist of an ODU and an installation kit in one container. Verify
the configuration as described in verifying the System Configuration. If there are discrepancies
between the packing list and the equipment received, contact your sales representative.
Inspect the equipment for any type of shipping damage. If any part of the shipment is damaged,
contact your sales representative for repair or replacement instructions.
2-2 Verifying the System Configuration
The MTI AP5822 system consists of an Outdoor Unit (ODU), POE and an installation kit.
2-3 Installation Kit
Most of the materials needed for installation are supplied with the system. Some tools and
equipment must be supplied by the user. Table lists materials in a typical installation kit. Refer
to the packing list for a description of the exact contents.