User Manual

A8 Configuration Manual - fm_1.2.6.3_v4.1.FCC.doc ASTRI Confidential & Restricted Access
Page 10 of 36

You must reboot the A8 to activate this setting.
3.7 A DVANCED C ONFIGURATION
More A8 Settings
P ARAMETER R ANGE C OMMAND E XAMPLE
Factory
<none> Set factory
SNTPServer
<ip address> Set sntpserver 10.0.0.5
TZONE
-12 to +14 Set tzone +8
Time
<none> Get time
acl
Strict Set acl strict
acl
Allow Set acl allow 00:01:22:f4:56:e8
acl
Del Del acl 00:22:33:44:55:66
Config Virtual
0 to 7 Config virtual 2
Active
Enable / Disable Set active enable
3.7.1 NTP (Network Time Protocol)
Command line syntax of collecting clock information from a NTP server:
set sntpserver 10.5.5.100
set tzone +8
reboot
where 10.5.5.100 is the NTP’s IP address
Note: You must reboot the A8 to activate this setting. You could check the clock by:
get time
3.7.2 ACL Configuration
Command line syntax of setting the ACL:
set acl strict
set acl <allow or deny> <client wlan card mac address>
reboot
An entry in the ACL can be removed as follows:
del acl <client wlan card mac address>
reboot
You must reboot the A8 to activate this setting.
Example:
set acl strict
set acl allow 00:20:A6:34:5E:23
del acl 00:02:20:30:44:55
reboot