User Manual

A8 Configuration Manual - fm_1.2.6.3_v4.1.FCC.doc ASTRI Confidential & Restricted Access
Page 11 of 36

3.7.3 Encryption (WEP)
Command line syntax of setting the WEP:
set encryption enable
set auth <open/shared/auto/WPA/WPA-PSK/WPA2/WPA2-PSK/WPA-AUTO/WPA-AUTO-PSK>
set keyentry <HEX/ASCII>
set key <1/2/3/4> <40/104/128> <KEY#>
reboot
You must reboot the A8 to activate this setting.
Example:
Set encry enable
Set auth shared
Set keyentry hex
Set key 1 40 1234567890
reboot
Note: It is easier to configure encryption in web-admin interface. Please refer to section 5.4.4 for
the details.
3.7.4 VAP (Virtual AP)
With the default settings, only virtual AP 0 is enabled. You could enable and configure VAPs by
the following CLI:
Config virtual <VAP#>
set active <enable/disable>
where <VAP#> is from 0 to 7, default is 0.
Note: A Reboot is not required to active this function. You could configure the corresponding
SSID, ACL, etc… under this virtual AP number.
Example:
Figure 5. VAP configuration in CLI