User Manual

A8 Configuration Manual - fm_1.2.6.3_v4.1.FCC.doc ASTRI Confidential & Restricted Access
Page 19 of 36

5.4 S ETUP – R ADIO P ARAMETER
The Channel, Output Power, SSID, and VAP (Virtual AP) can be configured by selecting Radio
in the tool bar, as shown in Figure 15.
5.4.1 Output Power
You can set the power for each sector in this area. You may also turn ON or OFF any sector
individually by selecting Disabled or Enabled in State.
5.4.2 SSID & VAP
For the VLAN, a single VAP is enabled in the default settings. The enabled VLAN, or VAP ID,
is indicated by the Up State, as shown in Figure 15.
The user can alter the individual VAP setting (including SSID) by selecting SSID. The setting of
each VAP is shown in Figure 16.
5.4.3 ACL
The ACL can be enabled by selecting Strict in the Access Control List in Figure 16. Clicking
Edit ACL Settings, a window, as shown in Figure 17, is shown to add MAC address (allow or
deny).
5.4.4 Encryption & Authentication
The encryption can be enabled by clicking the Enabled button in Figure 18.
After selecting Open-System or Shared-Key, the WEP key settings can be defined by clicking
the button Edit Cipher Settings, as in Figure 19.
WPA can be enabled by selecting WPA in Figure 18. The related settings are shown in Figure
20.
Note: Click the button Update to store the WEP or WPA settings.