User Manual

A8 Configuration Manual - fm_1.2.6.3_v4.1.FCC.doc ASTRI Confidential & Restricted Access
Page 12 of 36

3.8 802.11 A B RIDGE
802.11a function is an optional function requiring hardware to support. Only an A8 BTS having
a connector at the ‘a’ port can support this function, as shown in Figure 6.
Figure 6. A8 BTS with 802.11a bridge hardware – “a” port
The 802.11a bridge function is configured via WLAN 6 and is enabled in the default setting. It is
also set to transmit at maximum output power. You could use the following command to check
its state.
Config wlan 6
get wlan
get wirelessmode
Example:
Figure 7. 802.11a in A8 BTS