User Manual
A8 Configuration Manual - fm_1.2.6.3_v4.1.FCC.doc ASTRI Confidential & Restricted Access
Page 13 of 36
P
ARAMETER
R
ANGE
C
OMMAND
E
XAMPLE
Config wlan
0 or 6 Config wlan 6
Wlan
Enable / disable Set wlan enable
Channel
5180, 5200, 5220, 5240,
5260, 5280, 5300, 5320,
5745, 5765, 5785, 5805,
5825
Set channel 5765
PowerReduction
0 – 17 (1dB per unit) Set powerreduction 10
RemoteWbr
(MAC address of remote
bridge)
Add remotewbr 00:02:6F:23:12:34
The 802.11a output power is set to maximum value, which is 17dBm. The parameter
PowerReduction is used to reduce the output power relative to the maximum value. So, the
default value of PowerReduction = 0. If you want to reduce the 802.11a output power by 5dB,
you could type the following command in CLI:
Set Powerreduction 5
The following command is used to add or delete the remote bridge:
Add remotewbr <WBR MAC address>
Del remotewbr <WBR MAC address>
reboot
where <WBR MAC address> is the MAC address of the remote wireless bridge.
You could also view the number of remote wireless bridges configured with this A8:
Get association
Example:
Assuming you are trying to connect two A8’s with the following MAC address information:
A8_BTS_1 : 00:02:6f:23:41:EE
A8_BTS_2 : 00:02:6f:23:41:FF
In the CLI of A8_BTS_1:
Figure 8. Example – add remote wireless bridge