User Manual

A8 Configuration Manual - fm_1.2.6.3_v4.1.FCC.doc ASTRI Confidential & Restricted Access
Page 9 of 36

3.6 R ADIO CONFIGURATION
The following parameters related to radio interface will be discussed.
P ARAMETER R ANGE C OMMAND E XAMPLE
channel
1 – 11 Set channel 11
power
0 – 18 Set power all 21
ssid
(name of SSID) Set ssid B4
ssidsuppress
enabled / disabled Set ssidsuppress enabled
3.6.1 Channel
Command line syntax of setting the channel:
set channel <channel number>
where channel number: 1 - 11
Example:
set channel 11
3.6.2 Transmit Power
Command line syntax of setting transmit power:
set power <sector> <power level>
where sector: all, 0, 1, 2, 3
power level: 0 to 18, integer number in dBm
Note:
You could set the power level for a particular sector 0, 1, 2, 3 at different power level. Also, you
could set all sectors having the same power level. It is recommended to set all sectors at 21dBm;
i.e. sector = all, power = 21.
Example:
set power all 21
The above command sets all sectors transmitting at an output transmit power of 21dBm.
set power 2 17
The above command sets Sector 2 transmitting at an output transmit power of 17dBm.
Note: In order to comply with the FCC and Industry rules, please refer to Section 11 for the
guideline of power setting.
3.6.3 SSID & SSIDsuppress
Command line syntax of setting SSID:
set ssid <ssid>
where <ssid>: max. 10 alphanumeric characters
Example:
set ssid testing
Command line syntax of suppressing SSID:
set ssidsuppress enable
reboot