User Manual

6 MHX-2400 Operating Manual: Chapter 2 Initial Setup and Configuration
2.2 LED OPERATION
LED functionality is dependent on the mode of operation. Lines RX/SYNC,
TXMODE, and RSSI1,2 and 3 are designed to drive LED’s (active high).
LED
MODE RX/Sync TXMode RSSI1,2,3
Power Up (S0=1, S119=1) off off blink 500ms
on/500ms off
Power Up (S0=1, S119=0) off off off
Power Up (S0=0) off off off
Command Mode off off off
Data Mode - Master on while receiving
valid data packets
from slaves and
repeaters in the
network
on for the first
portion of each
hop interval.
RSSI mode
based on all
received packets
See Table 3
Data Mode - Repeater
During Sync. Acquisition
off off alternating
300ms on
Data Mode - Repeater
When Synchronized
on for first portion
of hop interval
on for second
portion of hop
interval
RSSI mode
based on packets
received from
Slaves*
See Table 3
Data Mode - Slave During
Sync. Acquisition
off off alternating
300ms on
Data Mode - Slave
When Synchronized
on on when
transmitting a
packet.
RSSI mode
based on packets
received from the
Repeater or
Master with
which it
communicates
See Table 3
*If Slaves have been silent for 2 seconds, repeater will base its RSSI on
packets received from the Master.