User's Manual

ManualsBrandsMicrohard Systems ManualsElectronicsMiniPCI BG 1W 2.4GHz

Features

• IEEE 802.11 b/g standard compliant

• Output Power of up to 30dBm @ b/g Band with built-in ESD Protection

•

RF ESD/EMP Immunity Threshold: 15KeV

①

•

Supports Atheros Proprietary "Super Mode" deliverin

up to 108 Mbps data link

rate

• Transmission Power Control (IEEE 802.11h TPC)

•

Extended distances and high performance due to optimized output signal

power

•

Multi-Country Roaming Supported (IEEE802.11d Global Harmonization

Standard)

•

Single MMCX antenna connector allowin

for improved mechanical stability and

low loss

• Ideal for long-distance, outdoor broadband wireless applications

MiniPCI BG 1W 2.4GHz

BG24-30

Summary of content (5 pages)

PAGE 1
MiniPCI BG 1W 2.4GHz XBG24-30 Features • IEEE 802.11 b/g standard compliant • Output Power of up to 30dBm @ b/g Band with built-in ESD Protection • RF ESD/EMP Immunity Threshold: 15KeV • • ① Supports Atheros Proprietary "Super Mode" delivering up to 108 Mbps data link rate Transmission Power Control (IEEE 802.11h TPC) Extended distances and high performance due to optimized output signal power Multi-Country Roaming Supported (IEEE802.
PAGE 2
TECHNICAL SPECIFICATIONS Chipset Atheros 2414 Host Interface PCI Interface v2.3 (Type III-B Mini PCI form factor) Operating 3.3 VDC Voltage 11b Cont. Tx@5.5M 5.0W Power 11g Cont. Tx@6M 5.5W Consumption 11g Cont. Rx 2.5W Standby 1.5W Antenna 1×MMCX (main) Connector 5.5 Mbps 2 Mbps 1 Mbps IEEE 802.11b： 11Mbps Data Rates IEEE 802.11g: 54Mbps 48Mbps 36Mbps 24Mbps Super-G: 108Mbps 96Mbps 72Mbps 54Mbps 2.412GHz ~ 2.462GHz (US & Canada) Frequency IEEE 802.11b/g: 2.412GHz ~ 2.472GHz (Europe) Range 2.412GHz ~ 2.
PAGE 3
ORDERING INFORMATION CODES ② SPEED Up to 108 Mbps XBG24-30 ① ② Comes with grounding cable Configurations are subject to change without notice DIMENSIONS DRAWING Carton Dimensions For 50pcs (pcs/ctn), 0.40m * 0.22m * 0.085m / 0.006 = 1.
PAGE 4
Compliance Information FCC Compliance Statement: This device complies with Part 15 of the FCC Rules . Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. This device must accept any interference received, including interference that may cause undesired operation. Product that is a radio transmitter is labeled with FCC ID.
PAGE 5
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.