Operating Manual

8 HP900 Operating Manual
3.2.3 Internal Cabling
The most common method for installing the module is to run a cable from
the RPSMA antenna connector on the application PCB to a reverse TNC
bulkhead connector on the chassis of the equipment as shown in
Figure 3. This cable can be purchased from Microhard Systems.
Figure 3 Suggested Internal Cabling
Cable losses are negligible for the short piece used within the chassis.
Additional losses up to 0.5 dB may be present in the RPSMA and Reverse
TNC connections.
RG316 Cable
with RPSMA male
connector
and Reverse TNC
bulkhead
connector
Reverse TNC Connector
RPSMA female connector
(HP900 OEM module installed on an
application PCB designed to the requirements
contained within this document.)
HP900