User Guide IPn4G IPn4G LTE Ethernet Bridge/Serial Gateway Document: IPn4G User Guide.v1.0.pdf December 2012 150 Country Hills Landing NW Calgary, Alberta Canada T3K 5P3 Phone: (403) 248-0028 Fax: (403) 248-2762 www.microhardcorp.
Revision History Revision 1.0 Description Initial Release © Microhard Systems Inc.
FCC/IC Regulatory Notice Modification statement: Microhard Systems Inc has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user’s authority to operate the equipment. Interference statement: This device complies with Part 15 of the FCC Rules and Industry Canada licence‐exempt RSS standard(s).
FCC / IC Avis réglementaire Instruction de modification: Microhard Systems Inc n'a pas approuvé les modifications apportées à cet appareil par l'utilisateur. Les changements ou modifications pourraient annuler l'autorité de l'utilisateur à utiliser cet équipement. Déclaration sur les interférences: Cet appareil est conforme à la Partie 15 de la réglementation FCC et Industrie Canada exempts de licence RSS norme (s).
2.0 Quick Start This QUICK START guide will walk you through the setup and process required to access the WebUI configuration window and to establish a basic wireless connection to your carrier. Note that the units arrive from the factory with the Local Network setting configured as ‘Static’ (IP Address 192.168.168.1, Subnet Mask 255.255.255.0, and Gateway 192.168.168.1), in DHCP server mode. (This is for the LAN Ethernet Adapter on the back of the IPn4G unit. 2.
2.0 Quick Start Connect A PC configured for DHCP directly to the ETHERNET port of the IPn4G, using an Ethernet Cable. If the PC is configured for DHCP it will automatically acquire a IP Address from the IPn4G. Open a Browser Window and enter the IP address 192.168.168.1 into the address bar. The factory default network settings: 192.168.168.1 IP: 192.168.168.1 Subnet: 255.255.255.0 Gateway: 192.168.168.1 The IPn4G will then ask for a Username and Password.
2.0 Quick Start © Microhard Systems Inc. Once successfully logged in, the System Summary page will be displayed. As seen above under Carrier Status, the SIM card is installed, but an APN has not been specified. Click on the Carrier > Settings tab and enter the APN supplied by your carrier in the APN field. Some carriers may also require a Username and Password. Once the APN and any other required information is entered to connect to your carrier, click on “Submit”.
2.0 Quick Start © Microhard Systems Inc. On the Carrier > Status Tab, verify that a WAN IP Address has been assigned by your carrier. It may take a few minutes, so try refreshing the page if the WAN IP Address doesn’t show up right away. The Activity Status should also show “Connected”. To access devices connected to IPn4G remotely, one or more of the following must be configured: IP-Passthrough, Port Forwarding, DMZ. Another option would be to set up a VPN.
150 Country Hills Landing NW Calgary, Alberta Canada T3K 5P3 Phone: (403) 248-0028 Fax: (403) 248-2762 www.microhardcorp.com © Microhard Systems Inc.
