Navigation Manual

5.4. Measurement mode selection
Average mode
a) If you would like to take average mode
measurement, please slidethe switch
toward «3» location.
b) In average mode, the unit will take 3
continuous measurements, and
afterwards calculate the result.
c) There will be15 seconds rest time
between measurements and the unit
will beep at the last 5 seconds to
remind you for the coming
measurement.
d) Data obtained in Average Mode are
indicated by a symbol.
Single mode
a) You would like to take single mode
measurement, please slide the switch
toward «1» location.
b) There is only 1 measurement each
cycle in single mode.
5.5. Measuring procedure
After the cuff has been appropriately positioned and the setting of the
pressure pre-selection has been undertaken, the measurement can begin:
a) Press the O/I button, the device will
check LCD segments then do auto-zero
calibration. In the meantime, 3 long
beeps and 2 short beeps sound.
Afterward, pump begins to inflate the
cuff. In the display, the increasing cuff-
pressure is continually displayed.
14