Use and Care

9
// www.micromatic.com
3.8 SHELVING INSTALLATION
1. Hook shelf rails onto shelf pilasters
2. Position all two shelf rails equal in distance from the oor for level shelves.
3. Wire shelves are oriented so that cross support bars are facing down.
4. Place shelves on shelf clips making sure all corners are seated properly.
4 // OPERATIONS
4.1 MECHANICAL (ANALOG) TEMPERATURE CONTROL
Before you connect the unit to the power supply, verify the thermostat is NOT in the OFF
position (the position of the thermostat must be different than zero). If the thermostat
is in the OFF position, the compressor will not run. Keep in mind, the evaporator fan
and lights will still have power while the thermostat is in the OFF position.
The knob of the thermostat is the temperature controller. This is located inside the
cabinet. Please be sure that the knob of thermostat is pointing to the yellow arrow
(Figure #3). This position is recommended by the factory to assure correct function of
the equipment (see Figure #1 below).
NOTE: Keep in mind, if you move the knob to a different position than the
position recommended from factory, the temperature will change, as well.
The knob position near the number one, gives you the warmest temperature and the
knob position near the number seven, gives you the coldest temperature.