Instruction manual

CHECKING
• Check that the carton has no damage. Should you
have any doubt about its condition, please do not
hesitate to contact your dealer.
UNPACKING
• Very carefully remove the unit from the box, taking
care to preserve all the packing material. In the unlikely
event that your unit needs to be sent back to either your
dealer or distributor, it must be sent in the original
packing material. Failure to observe this will invalidate
your warranty.
ACCESSORIES
Upon opening the carton, you should find the
following accessories:
• Mains lead.
• Dipole Antenna.
MAINS VOLTAGE
• Check that the mains voltage indicated on both the
carton and the rear of the unit correspond to the local
power supply
• If you are in any doubt, consult your dealer
.
INSTALLATION
In order to obtain the maximum performance of FM-
10, it is important to follow the installation instructions.
Wherever possible, we recommend that FM-10 is
installed in an audio rack or other suitable furniture
that provides sufficient ventilation.
CONNECTIONS
Having verified that the ON/OFF switch is on OFF
position, connect the mains lead provided to the rear
of the unit and to the wall socket.
Connect the interconnect cable from the rear of FM-
10 to your amplifier input. Connect the Antenna input.
POWER UP
You may now turn on FM-10 by switching the
ON/OFF switch located at the back of the unit.
The central LED lights up indicating that the unit is in
Standby mode. Press once on the STANDBY key of
the unit. The display indicates:
FM-10 TUNER FRONT PANEL
• ROTARY CONTROL : To access Frequency or
Pre-set selection
• SELECT : To switch between Manual or Pre-set
operation.
• SCANNING : To place the unit into automatic
station search mode.
• MEMORY : To store pre-set stations.
• MONO : Switches reception between Mono and
Stereo.
• MODE : To Switch between modes.
• STAND-BY : To switch the unit in and out of
Standby mode. A red LED located below the central
rotary control illuminates when in Standby mode.
•
DISPLAY
• On the left side the mode of operation, Manual
or Pre-set.
• In the middle the lock indicator.
• On the right side the frequency in MHz
• In RDS mode, the name of the station on the full
display.
Dear Customer,
Thank you for purchasing FM-10 tuner.
This unit provides ease of use and sonics of the highest quality. Please pay close attention to this
instruction manual, and read it fully before attempting to operate. It is designed to ensure that you
maximise your pleasure of FM-10 and familiarise you with its many unique functions.