Instruction manual

MANUAL TUNING
Manual tuning is useful when you already know the frequency of
the desired station.
• Press once on SELECT. FM-10 appears on the left side of the
display indicating Manual mode.
• Turn the central rotary control to the desired frequency. During
operation of the central rotary control, audio outputs will be
muted.:
• FM-10 is factory preset with RDS function activated. Two
seconds after locking on the selected station, the display will
indicate the name of the station according to the RDS standard :
AUTOMATIC SEARCH ( SCANNING )
Automatic search (scanning) allows you to scan the frequency
band upwards ( short press ) or downwards ( long press ).
• Press on the SCANNING key ( short or long press depending
upon the desired scanning direction ). FM-10 will start to scan until
it finds the next station of sufficient strength, whereupon the lock
indicator will light.
During search the display indicates:
If this is not a desired station, please repeat the operation..
PRESET STATIONS
Through the pre-set mode you can store and access up to 50
stations.
To store a station
• Locate the station that you wish to store either by manual or
scanning mode.
• Press once on the MEMORY key to open the memory.
The display will indicate the first available pre-set (ex. : P05) or
P- - should the memory be empty.
• Select the desired pre-set number (from 01 to 50) with the
central rotary control.
• Press the MEMORY key to store your selection. Repeat this
process to store your other selected stations.
Note : Any station that you store to an existing pre-set will
automatically overwrite the previous stored station.
Access to pre-set stations
• Press the SELECT key to access the pre-set mode.
• The display will indicate the pre-set number and the
corresponding frequency:
• Turn the central rotary control to access the desired pre-set
number.
• In order to return to manual mode, press the SELECT key.
MODE
The MODE key allows you to set up FM-10 input sensitivity and to
turn On or Off the RDS function.
• Press once on MODE. The display indicates :
FM-10 is set for the best reception with a cable antenna. If you are
using an individual antenna it is recommended that you increase
the input sensitivity of FM-10. During the 2 seconds while the
display indicates :
• Press once on STANDBY. The display indicates then:
This indication stays visible for 2 seconds while you can access
the LEVEL indicator to find the best position for your antenna.
• During the period when ANTENNA is displayed, press once
on STANDBY. The display indicates then:
Move the antenna until you obtain the strongest possible signal.
We recommend that you use a strong station for this purpose (ex
BBC ).
RDS Mode
FM-10 is factory preset with RDS activated. If you do not wish to
use this function you can de-activate it.
In CABLE mode, press twice on MODE.
In ANTENNA mode, press 3 times on MODE.
The display indicates :
This indication stays visible for 2 seconds while you can press on
STANDBY to de-activate this function. The dislay indicates then
for 2 seconds :
You can activate this function at any time by following the same
instructions as above.
FM-10 is now fully set up.