USER’S MANUAL ARIA
Dear Customer, Thank you for purchasing ARIA. This unit provides ease of use and sonics of the highest quality. Please pay close attention to this instruction manual, and read it fully before attempting to operate. It is designed to ensure that you maximise your pleasure of ARIA and familiarise you with its many unique functions. CHECKING INSTALLATION Check that the carton has no damage. Should you have any doubt about its condition, please do not hesitate to contact your dealer.
POWER UP PLAY You may now turn on ARIA by switching the ON/OFF switch located at the back of the unit. A message “ARIA” is written for a second. Open the cover and place a disc. Be careful to place correctly the puck at the centre.
SEARCH ABSOLUTE PHASE A long pressure on the PREV key will allow you to search for a passage in reverse direction whereas a long pressure on the NEXT key will allow you to search for a passage in the forward direction. The time that you continue to press the key determines the speed of the search. For the first five seconds the output volume is reduced, then the search speed is increased and the sound is muted because the jumps are too big to deliver an accurate audio signal.
A/B REPEAT OTHER AVAILABLE FUNCTIONS RC5 - system 20 - command 59 Those functions are neither on the keys of ARIA nor the remote but can however be accessed with a programmable remote. Press the A-B key while in play at the starting point of the passage that you wish to repeat. The display indicates: For people willing to program such a remote, we indicate under the title of each function the code used, the system and command numbers.
TECHNICAL CHARACTERISTICS Audio Characteristics Bandwidth (- 0.5dB)…………………………………………………………………………………………........... DC – 20Khz Linearity at –90dB…………………………………………………………………………………………………..…….. < 0.5dB Signal/noise ratio + THD ……………………………………………………………………………………... < -96dB at 1 kHz Crosstalk……………………………………………………………………………………………………….. >100dB at 1 kHz Digital to Analog conversion…………………………………………………………………………………………1 bit / 256 fs Impedance …………………………………………………………………………………………………………………...
RS232 ARIA 1. TECHNICAL SPECIFICATIONS Baud rate Data Stop bits Parity bit Flow control : : : : : 19200 bauds 8 bits 1 none none Wiring diagram: pin 2 : Tx pin 3 : Rx pin 5 : Gnd 2. COMMAND FORMAT Each command must be sent using the following prototype: $,ARIA,⊔,COMMAND,[DATAS],€ • • • • • • $: decimal 36, start byte. ARIA: device identifier. ⊔ is the space required between header and command. COMMAND: 1 byte. Available commands are given next page. DATAS : 0 to n bytes. € : decimal 128, end byte.
AVAILABLE RS232 COMMANDS Simple RS232 Commands Command Reset Clear program Phase inverted/ non inverted RC5 command Commands with return values Data 48 49 ASCII 0 1 50 2 62 > RC5 code see Table Track select 84 T *** track (0..99) Program 80 P track 1 (0..99) *** … *** track n (0..99) *** 67 C Program cancel track 1 (0..99) *** … *** *** track n (0..