ADDENDUM Micro-DCI™ Single Loop Controller 53SL5100A Rev. 1 Firmware PN24585 Rev. 1 NOTE: The purpose of this addendum is to supplement and provide additional information applicable to the Micro-DCI™ 53SL5100A Single Loop Controller Instruction Bulletin (PN24469).
MicroMod Automation, Inc. The Company MicroMod Automation is dedicated to improving customer efficiency by providing the most cost-effective, application-specific process solutions available. We are a highly responsive, application-focused company with years of expertise in control systems design and implementation. We are committed to teamwork, high quality manufacturing, advanced technology and unrivaled service and support.
53SL5100 Single Loop Controller Rev. 1 Firmware 1.0 APPLICABLE DOCUMENTATION This addenda publication contains additional information applicable to the Micro-DCI™ 53SL5100A Instruction Bulletin, SIngle Loop Controller. 1.1 SCOPE OF CHANGES Contact Closure Output 1 (CCO-1) functionality is added to the 53SL5100A Single Loop Controller as a result of Revision 1 to the firmware EPROM. CCO-1 operates with Control Strategies 1, 3 and 4 of the Single Loop Controller.
53SL5100 Single Loop Controller Rev. 1 Firmware 3.0 PROCESS ALARMS 1 AND 2 (PA1 AND PA2) As with CCO-0, the purpose of CCO-1 is to convert a logic level to a hardware contact condition. The logic levels applicable to CCO-0 are now selectable from Process Alarm 1 (PA1) alone, or either Process Alarm 1 or 2 (PA1 or PA2). The logic level applicable to CCO-1 is PA2 only.
The Company’s policy is one of continuous product improvement and the right is reserved to modify the information contained herein without notice, or to make engineering refinements that may not be reflected in this bulletin. Micromod Automation assumes no responsibility for errors that may appear in this manual. © 2004 MicroMod Automation, Inc. MicroMod Automation, Inc. 75 Town Centre Drive Rochester, NY USA 14623 Tel. 585-321-9200 Fax 585-321-9291 www.micromodautomation.