Instruction Manual

Logic Functions - Book 1
SYSTEM EVENT BLOCK
3-37
23
Report Diagnostic Event: Enabled (RDGENA) .........................................................CWR
Used to enable the reporting of the event.
YES 1 Report when a diagnostic event suppression attribute is set to
NO to the system event queue.
NO 0 No reports are made.
24
Report Alarm Event: Goes active and unacked (RALAU) .......................................CWR
Used to enable the reporting of the event.
YES 1 Report when a PA or NM alarm goes active and unacknowledged
to the system event queue.
NO 0 No reports are made.
25
Report Alarm Event: Goes active but not unacked (RALANOTU)..........................CWR
Used to enable the reporting of the event.
YES 1 Report when a PA or NM alarm goes active but not
unacknowledged because it’s priority level is zero to the system
event queue.
NO 0 No reports are made.
26
Report Alarm Event: Goes active while unacked (RALAWU) .................................CWR
Used to enable the reporting of the event.
YES 1 Report when a PA or NM alarm goes active while it is still
unacknowledged to the system event queue.
NO 0 No reports are made.
27
Report Alarm Event: Goes clear while unacked (RALCWU) ...................................CWR
Used to enable the reporting of the event.
YES 1 Report when a PA or NM alarm goes clear while it is still
unacknowledged to the system event queue.
NO 0 No reports are made.
28
Report Alarm Event: Goes clear while acked (RALCWA)........................................CWR
Used to enable the reporting of the event.
YES 1 Report when a PA or NM alarm goes clear while it is
acknowledged to the system event queue.
NO 0 No reports are made.
29
Report Alarm Event: Cleared by suppression (RALCBYS) .....................................CWR
Used to enable the reporting of the event.
YES 1 Report when a PA or NM alarm is cleared by any method of
suppression to the system event queue.
NO 0 No reports are made.