Instruction Manual

Logic Functions - Book 1
CONFIGURED LIST BLOCK
3-51
00
Version (VERSION)............................................................................................................– – R
Attributes 8, 9 and 10 were added for version 2 of this block.
01
Block Length (BLKLEN).....................................................................................................– – R
Number of data base bytes taken by the block.
02
State (STATE).....................................................................................................................– – R
This block is always RUN (block is executed). See Section 2.4.1, State Changes for
additional information on block states.
03 Bad Inputs Accepted (BADINP)...........................................................................................– – R
This block always collects data without a check on input quality and output quality is set to
good. See Section 2.3.2, Data Quality for additional information.
04 Collect Data (COLLECT)................................................................................................... C – R
Collect data is presently used by the configurator to determine if a configured list block is part
of the data collection process or is for non-foreground TIF file building only.
YES 1 Configured list data is collected. To put data in foreground, the list
must be part of a list specified in the ICN block.
NO 0 No data is collected and no database space is allocated by
configurator (block does not appear as part of the instrument
database). This feature is used to identify PC-30 system variables for
non-foreground Tagged Interface File (TIF) generation. The TIF file
resides at the PC for use with PC-30.
05
Packed Length (PKDLEN)...................................................................................................– – R
The number of bytes of listed data, including any nested lists, in packed format.
06
Unpacked Length (UNPKDLEN) .........................................................................................– – R
The number of bytes of listed data, including any nested lists, in unpacked format.
07
List Signature (LISTSIGN)...................................................................................................– – R
This is a number which uniquely identifies a particular set of LSPs in a particular order. Users
(of foreground for instance) can monitor this value to verify that the same data is being
collected.
08 Collect Quality (COLLQUAL)............................................................................................ C – R
Collect quality should only be used if the host system driver can deal with data quality.
YES 1 If Collect Data is also YES and the listed attribute has quality, then the
quality data is collected and stored.
NO 0 Default. No quality data is collected and stored.
09
Discrete Length (DISCLEN) ................................................................................................– – R
The number of bytes in the discrete area of the input buffer for this list.
10 Non Discrete Length (NDISCLEN) ......................................................................................– – R
The number of bytes in the non discrete area of the input buffer for this list.