WCDMA Tracker Prime One User Manual Revision: 1.00 Document Title Prime One User manual Version 1.
Contents 1 Introduction...................................................................................................................................... 3 2 Product Overview............................................................................................................................ 3 2.1 Appearance............................................................................................................................3 2.2 Buttons/Micro USB Interface Description........................
1 Introduction Prime One is a powerful GPS locator which is designed for vehicle, pets and assets tracking. With superior receiving sensitivity, fast WCDMA frequencies 850/1900 and GSM frequencies 850/900/1800/1900. Its location can be real time or schedule tracked by backend server or specified terminals.
Function Key Geo-Fence mode Long press the key to enable/disable Geo-Fence ID0 Geo-Fence in current position mode Long press the key to enable/disable Geo-Fence ID0. If enable Geo-Fence ID0, using the current position as the centre of Geo-Fence 0. SOS mode (default) Long press the key to active SOS alarm Micro USB interface Connect a 5V DC adapter can power on Prime One and charge the internal battery Connect a 3.
Fully charged Solid In charging Slow flash 3 Getting Started 3.1 Parts List Name Picture Remark Prime One Locater The WCDMA/GPS locator. AC-DC Power Adapter It is used to charge the internal battery of Prime One. Prime One Data and charger Cable It the USB data cable which can be used for firmware upgrading and configuration. It also includes the charger interface on the Prime One. 3.2 Battery Charging The following items are suggestion for battery charge, please pay more attention.
Charging will last about 5 hours. Note: If the Prime One device is firstly used, please make sure the battery is fully charged, which will make the life of battery much longer. 3.3 Prime One Data Cable Prime One Data Cable is a cable with a Micro USB connector. The USB data cable is used for data download, which will be used for firmware update or configuration and can be used for charging at the same time. Figure 2-1 3.
protocol. 4 Trouble shooting and Safety info 4.1 Trouble shooting Trouble Possible Reason Solution Messages can’t be reported to the backend server by Mobile network. APN is wrong. Some APN can not visit the internet directly. Ask the network operator for the right APN. The IP address or port of the backend server is wrong. Make sure the IP address for the backend server is an identified address in the internet. Unable to power off Prime One. The function of power key was disabled by AT+GTFKS.
FCC Caution. § 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.
back of the handset kept 0.5 cm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 0.5 cm separation distance between the user's body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided.
