BLE Pendant AIRE Mate100 G User Manual Revision: 1.00 Document Title AIRE Mate100 G User manual Version 1.
Contents 1 Introduction .................................................................................................................................... 3 2 Product Overview .......................................................................................................................... 3 2.1 Appearance .......................................................................................................................... 3 2.2 Buttons Interface Description ...................................
1 Introduction AIRE Mate100 G is a BLE Pendant which is designed as accessory for Emergency call equipment. It works on BLE protocol .It will report Beacon broadcast data by custom protocol After the SOS button being long press for 3 seconds. The AIRE100V device which receiver the Beacon broadcast will dial a emergency call. The G-sensor function will be activated and report Beacon broadcast data by custom protocol once the device is in alerting state.
2.3 LED Description Figure 1-2 There are 3 LED lights in AIRE Mate100 G device, the description as following. Light Event State RED LED Normal Dark Power on Solid for 1 second SOS key was long pressed for 3 seconds Solid for 2 seconds Normal Dark Power on Solid for 1 second Normal Dark Power on Solid for 1 second During the progress of OTA Flash every 5 seconds Green LED Blue LED 3 Getting Started 3.
Name Picture Remark The LTE Base Station. will dial a AIRE100V Base Station emergency call when receiver the Beacon broadcast. The Pendant will report Beacon AIRE Mate100 G Pendant broadcast data by custom protocol . 3.2 Built-in Battery The following items are suggestion for built-in battery usage, please pay more attention. The device is a pendant ,which is designed to be used with AIRE100V Base station . There is a button battery(CR2450) integrated in device.
Figure 2-1 3.4 Power on/Power off Figure 2-2 Power on: The Pendant will automaticly power on when the button battery is assembled . Power off: UnPlugged the button battery. Note: the user can change the button battery when the battery is dead.
5 Trouble shooting and Safety info 5.1 Trouble shooting Trouble Possible Reason Solution Unable to power on AIRE Mate100 G. The battery run out or dead. change the button battery(CR2450) Beacon broadcast data The PD001 is not in the Add the SN of PD001 in the of AIRE100V by custom protocol can not be received 5.2 Safety info The following items are suggestion for safety use, please pay more attention. Please do not disassemble the device by yourself.
§15.105 Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
