Network Router User Manual

19
Open debug message will show up specific information while VoIP FXO
gateway is in operation. After executing the debug command, it should
execute command debug -open as well. One example is demonstrated
below.
usr/config$ debug -add h323 vp
usr/config$ debug -open
Parameters Usage:
-status Display the enabled debug flags.
-add Add debug flag.
-- h323 : h323 related information
-- vp : voice related information
-delete Remove specified debug flag.
-open Start to show debug messages.
-close Stop showing debug messages.
5.4 [reboot] command
After commit command, type reboot to reload VoIP FXO gateway in new
configuration. The procedure is as below:
usr/config$ reboot
Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
AC4804[0] is OK
AC4804[1] is OK
AC4804[2] is OK
Successful
Initialize OSS libraries...OK!
open stack successful
cmInitialize succeed!
GK mode selected.
login:
5.5 [flash] command
This command will clean the configuration stored in the flash rom and reboot
VoIP FXO gateway in factory default setting.
Parameter Usage:
-clean clean all the user-defined value, and reboot VoIP FXO gateway
in factory default mode.
Note:
It is recommended that use “flash –clean” after application firmware id
upgraded.