Network Router User Manual

18
3. Initial Configuration
This chapter describes the procedure for the initial configuration of SP5001/S. Refer to
the relevant chapters in this User’s Manual for descriptions of the fields and buttons
within individual screens.
3.1 General Configuration
SP5001/S has a factory default IP address of 10.1.1.3 and a subnet mask of
255.0.0.0.
3.2 Static IP address
Step 1. To configure the IP address of SP5001/S, click Network Interface on the
navigation panel. In the Network Interface screen, type a new IP address,
subnet mask and the default routing gateway (e.g. IP Address: 192.168.4.71,
Subnet mask: 255.255.0.0, Default routing gateway: 192.168.1.254) and click
the OK button.
Figure 4. Network Interface
Step 2. Click Commit Data on the navigation panel. In the Commit Configuration Data
screen, click the Commit button. In the Commit Configuration Data screen to
Display Commit to Flash OK!, When the Commit Data Ok.