Network Router User Manual

23
Step 3. Click Commit Data on the navigation panel. In the Commit Data screen,
click the Commit button. In the Commit Data screen to Display Commit to
Flash OK! when the Commit Data Ok.
Step 4. Click Reboot Data on the navigation panel. In the Reboot FXS System
screen, click the Reboot button. It will take 40 seconds to reboot.
Step 5. Close the current browser windows and launch your web browser again.
Enter the new IP address in the Location or Address field. Press [Enter].
Two sets attached to IP Sharing Device (Router)
Assign an IP address to each set using DHCP or fixed address.
Enable the IP Sharing function for each set using following command.
Fixed IP Address – usr/config$ ifaddr –ipsharing 1 210.11.22.33
Configure separate SIP port and RTP port for each set to prevent from port conflict.
For example, if set A uses the default settings (SIP port: 5060, RTP port: 16384), you
must change set B’s setting to SIP port equal to 5061 and RTP port equal to 26384 for
instance.
Change SIP port – usr/config$sip –port 5061
Change RTP port– usr/config$sip –rtp 26384
Use the Port Forwarding or Port Redirection function provided by IP Sharing device
(Router).