Network Router User Manual

19.2 Power Up Your SP5001/S

At this point, you should have connected the console port, the LAN Port, the WAN port

and the power port to the appropriate devices or lines. Plug the power adapter into a

wall outlet. The Power LED should be on. The Status LED will come on after the

system tests are complete. The WAN LED and one of the LAN LEDs come on

immediately after the Status LED come on, if connections have been made to the LAN

and WAN ports.

Initial Screen

When you power on, your SP5001/S will perform server internal tests as well as line

initialization.

After the tests, SP5001/S asks you to enter the Login, as shown.

Attached TCP/IP interface to cpm unit 0

Attaching interface lo0...done

Please wait while system is initializing .......... SAttached TCP/IP interface

to cpm unit 0

Attaching interface lo0...done

WorkMode : PEER2PEER_MODE

AC4804[0] is ok

successful 1 2

Initialize OSS libraries...OK!

VP v1.40 stack open successfully.

Figure 34. Initial Screen

Entering Login

For you first login, enter the login root and default password “Null”. As you type the

password, the screen displays and (*) for each character you type.

AC4804[0] is ok

successful

Initialize OSS libraries...OK!

VP v1.40 stack open successfully.

Welcome to Terminal Configuration Mode

Please enter your configuration item

usr/config$

Figure 35. Login Screen

Note: root or administrator is the default login name and there is no password needed.