Network Router User Manual

command. For detail, please refer to Chapter 19.7.13 [security]

command.

An example is demonstrated below:

usr/config$ security –line 1 –name 12345 –password 12345

Note: This is to set username (userid) as “12345”, password as “12345” into

line1, which means line1 can accept incoming calls after successfully

registered to Proxy server.

Step 2. You must specify Proxy address obtained from your service

provider. And the Proxy address can be IPv4 address as well as

DNS name. For detail, please refer to Chapter 19.7.12 [sip]

command.

Several important SIP parameters are listed below when setting proxy mode:

“–px” and ”–line1”.

An example is demonstrated below:

usr/config$ sip –px 210.68.222.33 -line1 0506

Note:

1. This is to set proxy address as “210.68.222.23”, line1 number as “0506”.

2. The line number of line1 depends on what you get from your service

provider.

Step 3. Confirming the values, type commit and press enter to save all the

changes you have done.

Step 4. Type reboot and press enter to reboot SP5001/S.

Step 5. Wait for SP5001/S to initialize in Proxy mode. It should take around

40 seconds. And you will see the below information displayed on

Hyper-Terminal if the registration is successful.

Attached TCP/IP interface to cpm unit 0

Attaching interface lo0...done

Please wait while system is initializing .......... SAttached TCP/IP

interface to cpm unit 0

Attaching interface lo0...done

WorkMode : PROXY_MODE

Start registering to Proxy server

Registering to: Sip:80.248.33.37 with the following :

To:sip:sipcenter1123@80.248.33.37

From:sip:sipcenter1123@80.248.33.37

Contact:sip:sipcenter1123@210.59.163.143