Network Router User Manual

59
>Advanced setting > NAT setting > Port Redirection
Active Configuration
Items Service name Protocol Actual Port Virtual IP Virtual Port Enable
1 1 UDP 5060 192.168.1.10 5060 v
2 2 UDP 16384 192.168.1.10 16384 v
3 3 UDP 16394 192.168.1.10 16394 v
4 4 UDP 5061 192.168.1.11 5061 v
5 5 UDP 26384 192.168.1.11 26384 v
6 6 UDP 26394 192.168.1.11 26394 v
7 --- 0 0 x
8 --- 0 0 x
9 --- 0 0 x
10 --- 0 0 x
Note:
1. Different Vendor’s Router will have different appearance of setting.
2. Once you set the DMZ Host, you don’t need to configure the Port
Forwarding and vice versa.
3. If there is only one SP5001/S attached to the IP Sharing device, it is
recommended to use DMZ Host setting to enable the NAT traverse and
disable the Port Forwarding.
4. If there are two or more sets of SP5001/S attached to the IP-Sharing
device, please configure the Port Redirection (Forwarding) to enable the
NAT traverse and disable the DMZ Host.
5. After the IP Sharing configuration of SP5001/S and IP Sharing device is
complete, you must reboot SP5001/S to activate the new settings.