Network Router User Manual

63
19.6 Commands in SP5001/S
The following table lists all of the commands that you can use in SP5001/S. Refer to
the following chapters for descriptions of commonly used commands.
This user’s guide describes commands that are helpful for configuring SP5001/S.
Using commands not documented in the user’s guide can damage the unit and possibly
render it unusable.
Table 16. Commands in SP5001/S
Command DESCRIPTION
help help/man/?[command]
quit quit/exit/close.
debug show debug message.
reboot reboot local machine.
flash clean configuration from flash rom.
commit commit flash rom data.
ifaddr internet address manipulation.
time show current time.
ping test that a remote host is reachable.
pbook Phonebook information and configuration.
pppoe PPPoE stack manipulation.
sysconf System information manipulation.
sip This command is to configure SIP related parameters.
security This command is used to configure the account information included
username and password obtained from the service provider.
voice Voice information manipulation.
support Special Voice function support manipulation.
tos TOS service allows users to achieve QoS on IP network.
phone Setup of call progress tones and ringing (SLIC control).
rom ROM file update.
passwd Password setting information and configuration.