Network Router User Manual

64
19.7 System Commands Overview
19.7.1 [quit]
Type quit will quit configuration mode. And turn back to login prompt.
usr/config$ quit
Disconnecting...
login: root
Welcome to Terminal Configuration Mode
Please enter your configuration item
Figure 37. quit command list
Note: It is recommanded that type the “quit” command before you leave the
console. If so, SP5001/S will ask password again when next user connects to
console port.
19.7.2 [debug]
Open debug message will show up specific information while Gateway is in
operation. After executing the debug command, it should execute command
debug -open as well. One example is demonstrated below.
usr/config$ debug
Debug message information and configuration
Usage:
debug [-add type1 [[type2]...]] | -open | -close | -status
-status Display the enabled debug flags.
-add Add debug flag.
-delete Remove specified debug flag.
-open Start to show debug messages.
-close Stop showing debug messages.
Example:
debug -add sip msg
debug -open
usr/config$
Figure 38. debug command list
In this example, user open debug flags including sip, msg.
usr/config$ debug -add sip msg
usr/config$ debug –open