Network Router User Manual

75
19.7.12 [sip]
This command is to configure SIP related parameters.
usr/config$ sip
SIP stack information and configuration
Usage:
sip [-mode pxmode]
sip [-px address] [-domain domain] [-prefix prefixstring]
[-line1 number]
[-expire t1] [-port udpPort] [-rtp rtpPort]
sip -print
-print Display SIP stack information and configuration.
-mode Configure as Proxy mode or Peer-to-Peer mode.
-
px Proxy server address. (Proxy IPv4 address or Proxy dns
name)
-pxport Proxy server port. (the port of proxy)
-
domain Specify domain name in the URL (if domain name is not
used,
specify as
null)
-prefix Specify prefix string, use it when UserID contains
alphabets
(if UserID uses numerals, specify as null)
-line1 TEL1 Phone number.
-expire The relative time after which the message expires(0 ~
(2^31-1))
-port SIP local UDP port number (5060~5070), Default: 5060
-rtp RTP port number (2326~65534), Default: 16384
Example:
sip -px 210.59.163.171 -line1 70
usr/config$
Figure 54. sip command list
Parameter Usages:
-mode Configure as Proxy mode or Peer-to-Peer mode (0:
Peer-to-Peer mode, 1: Proxy mode).
-px to specify Proxy address when SP5001/S is in proxy mode.
Proxy address can be IPv4 address or DNS name.
-domian specify the domain name such as “sipcenter.com” and it will be
presented in the URL ([e-mail]).
-prefix when your username contains alphabets, for example sip1123,
specify the prefix string as “sip”.
-line1 assign line 1 number.
-expire this parameter is used to inform proxy server the valid duration