Hardware Guide

z
Rev. 3 Micronet SmartCAM™ - Hardware Guide 27 / 50
Figure 10: Micronet SmartCAM Standard & Intermediate Model Cable Pinout
Power Connector
The power connector (marked as P1) is a 4-pin, 2 row MicroFit 3.0 series Molex male connector and the
pinout for power and ignition lines are described in figure 11 below:
Figure 11: Molex 4-Pin Male Connector
Power Consumption
Table 5: Micronet SmartCAM™ Intermediate Current Consumption
Micronet SmartCAM™ Intermediate Current Consumption
12V
24V
~200mA
3mA
Serial Communication
The intermediate model similarly supports a serial communication port for external device connection, and
a debug port connected to the MCU Co-Processor. These ports support various hardware and software flow