Specifications

5.4 Surface Mounting

Where there is no access to the rear of the mounting surface

Easy installation but will allow removal without gaining access to the

boat. Position the supplied Template carefully before starting.

1. Drill three 2.5mm holes marked "B" on the template.

2. Carefully snap the facia of the display off the main body taking care

not to drop the button pads.

HINT – It may be useful to place a piece of sticky tape across the

front of the buttons before removing the facia to prevent them from

falling out during the installation.

3. Remove the three captive M4 nuts from the plastic moulding and

attach the display to the mounting surface using the three self

tapping screws provided. Take care not to over tighten the screws as

this may cause the moulding to crack.

4. Check the display is perfectly level; carefully position the button

inserts into the correct slots and snap the facia back into position.

Temporary Mounting

1. Use the double sided tape provided to secure the display to a

suitable mounting surface. Press the display firmly against the

surface until secure.

Note: This method is recommended for temporary use only. For example,

finding an appropriate location before drilling holes.

Installation