Specifications

2.2 Switching the System On and Off
To switch your Micronet system on or off select any display and press
the button for 2 seconds.
2.3 Backlighting
At any stage of the display’s operation press and hold for 2 seconds the
button to access the lighting control.
Pressing the and buttons will scroll through the options:
OFF, 1, 2 and 3 whilst changing the backlighting.
Depending on the display setup (see page 15 -s9), backlighting
on the whole system or just the single display will be altered.
Backlighting is automatically switched off in daylight as part of the
display’s power saving feature and will not operate in daylight.
2.4 Audible Signals and Alarms
At stages during its operation your Micronet display will beep to indicate
alarms or moments of importance.
Power-up Once operating as part of a network the display will issue a single
beep as it is switched on by pressing the button for 2 second.
Button Press A single beep is issued each time a button is pressed. A second
beep is issued after a 2 second hold down of the button.
Alarm Continuous bursts of three beeps indicates a lost network alarm.
The alarm is indicated on the digital display. Pressing any button
will silence the alarm. See fault finding section on p23.
mn100 Analogue Display
6
www.tacktick.com
Switch On Switch Off