Specifications

mn100 Analog Display

5.4 Surface Mounting

5.4.1 Where there is no access to the rear of the

mounting surface

Easy installation but will allow removal without gaining access to the

boat. Position the supplied Template carefully before starting.

1. Drill three 2mm holes marked “SURFACE” on the Template

2. Carefully snap the facia of the instrument off the main body

taking care not to drop the button pads.

HINT – It may be useful to place a piece of sticky tape

across the front of the buttons before removing the facia to

prevent them from falling out during the installation.

3. Remove the three captive M4 nuts from the plastic moulding

and attach the instrument to the mounting surface using the

three self tapping screws provided. Take care not to over

tighten the screws as this may cause the moulding to crack.

4. Check the instrument is perfectly level, carefully position the

button inserts into the correct slots and snap the facia back

into position.

5.4.2 Temporary Mounting

1. Use the double sided tape provided to secure the instrument

to a suitable mounting surface. Press the instrument firmly

against the surface until secure.

Note: This method is recommended for temporary use only.

Operation

2 – Operation

Important:

Ensure that the “Auto Network” procedure described on the yellow

instruction sheet and full Setup and Calibration has been performed

correctly before attempting to use your Micronet instruments for

navigation purposes.

2.1 Instrument Display Information