User guide

Installation
5
www.tacktick.com
English
Installation
Installing the Wind Display
Tools required: 5mm (3/16 inch) drill bit
24mm (1 inch) hole saw (or 12mm (1/2 inch) drill bit)
Power Drill
Parts supplied: Mounting Template (from the back of this user guide)
Mounting studs with thumbnuts (3)
Crimp receptacles (4)
Positioning the display
For best wireless performance, tacktick recommend that the display is
mounted on a GRP or acrylic surface.
Select a flat, smooth, surface that has access to the rear for the power
supply cable and the studs and thumbnuts.
If installing more than one display leave space between them for sun covers.
Avoid areas where damage may occur (winch handles, feet, warps etc.)
Check for clarity of vision and ease of access to the control keys.
Warning:
it is recommended that displays are NOT positioned where
your arm must pass through the steering wheel to operate the keys.
Mounting
Position the Template carefully before starting.
1. Drill the three 5mm holes marked
"A" on the template.
2. Using a hole saw cut the 24mm
hole marked "P" on the template.
Alternatively, drill two 12mm holes
and smooth them together. with a
sharp knife or small file.
3. Remove the protective mask.
4. Pass the power cable through the
hole and push the receptacles
firmly onto the spades on the rear
of the display, taking care to
ensure the correct polarity.
5. Screw the three studs provided into the holes in the back of the display.
6. Place the display in position, pushing the three studs through the holes.
7. Secure the display using the thumbnuts, making sure it is level before
final tightening. Do not tighten hard.
8. Support the power cable by securing it to a fixing stud with a cable tie.
Thumb nut
Power cables
Fixing stud
Power
Connectors
Remove
protective mask