User's Manual

15
box next to it, and click “Remove”, then reboot the hub. On rare occasions, a test camera remains installed from
the tesng done during manufacturing.
2. To add a camera type the camera MAC address into the box provided. (If your camera is powered on, you may
see it indicated as a choice in a pull down menu)
3. Select the camera or enter the camera MAC address into the box, name the camera, and click “Save”.
4. Click the “refresh” buon every few seconds unl the new MAC address appears in the list of acve cameras.
5. Repeat the process for addional cameras.
4. When you have added all the cameras to the hub (up to a maximum of 4), reboot the hub by clicking on the
“Restart” buon at the top of the screen, and following any prompts.
Removing Cameras
In some circumstance (such as moving a camera to another locaon on to a dierent hub, replacing a camera,
etc.…) you may need to “remove” a camera. To remove a camera from a hub, simply click on the camera you wish
to remove, and click on the “Delete” buon. The camera will be removed from the system’s database, and may
then be replaced, or moved to another hub.
Aer successfully removing any cameras, you should reboot the hub by clickign on the “restart” buon found at
the top of the screen.