User's Manual
Table Of Contents
- Package Contents
- MicroPower System Overview
- Getting Started - First Steps
- Receiverx Installation
- Receiverx System Setup
- Camera Kit Assembly & Installation
- Camera System Installation / Mounting
- Focusing and Adjusting The Camera
- VMS Integration
- FAQ
- Trouble Shooting
MicroPower Technologies
1-877-536-0128 | micropower.com
22
Solar Panel Assembly
The solar panel bracket is extremely versale, and is assembled based upon the mounng surface that it will be
aached to. The “C” shaped bracket can be bolted to the solar panel with the at side facing out (for bolng/
screwing to smooth surfaces), or with the edges of the bracket facing outward (for mounng using straps/hose
clamps to poles). The panel may be mounted to poles, walls, or even inverted and mounted to rooops or ledges.
(See images).
Bracket congured for mounng to a round or square pole by
use of hose clamps / straps. (straps through the slots in bracket)
Assembly of the bracket, and the arrangement of the nuts, bolts, and washers.
Bracket congured for mounng to a at surface such as a wall,
by use of screws or bolts
Solar bracket congured for mounng down, to a at surface
such as rooop or ledge with the solar panel facing upward.
Solar panel mounted to a pole using stainless steel hose clamps that are passed through the
slots in the bracket. This allows for a quick, non-permanent installaon that may be easily
relocated, without damaging the mounng surface.