User's Manual
Table Of Contents
- Package Contents
- MicroPower System Overview
- Getting Started - First Steps
- Receiverx Installation
- Receiverx System Setup
- Camera Kit Assembly & Installation
- Camera System Installation / Mounting
- Focusing and Adjusting The Camera
- VMS Integration
- FAQ
- Trouble Shooting
29
Focusing and Adjusng The Camera
The system uses common “CS-Mount” threaded, mega-pixel CCTV lenses. Standard MicroPower cameras come
equipped with either a 2.8-11mm IR corrected lens, or a 10-40mm IR corrected lens. All the lenses are equipped
with a manual iris control, that in most circumstances, should always be opened up completely to oer the best
low light performance. The telephoto and focus controls should be adjusted to provide the desired eld of view
and magnicaon.
Remember, these are wireless cameras that are more exible for mounng than tradional wired CCTV, so
whenever possible you should try to bring the camera closer to your target, rather than resorng rst to magnifying
it through a more powerful lens. Closer posioning will provide greater clarity and beer low light performance,
and more “pixels on target”.
Note: There are sensive components exposed inside the camera, such as the CCD imager board, and the diplexer
board (seen below). Take care not to touch these parts when focusing the camera, parcularly if the camera is
powered on.
Solveil Camera Equipped with a 2.8-11mm Lens
Main board and the CCD Imager board.
These are sensive parts of the camera system.
Try to avoid contact with these components when
making camera adjustments
Focus Control
Iris Control
Zoom Control